This week I continued with the steam engine, this week I created the wheel bearing part of the engine. First I built the housing part of the bearing using polygons, tweaking the model by adjusting the vertices, adding an edge loop to create the correct curve at the end.
This model required careful adjustment on my part. I had to ensure that the sides were smooth by creating a polygon and scaling it to the appropriate shape, then manipulating the edges and vertices to create the surface edges and smooth them out.
This is the part where the base is built
I made two electrical conduits to connect two models
I then proceeded to the assembly of the model, this part being the wheel and bearing part of the steam engine.
Next, I made the connecting rod inside the wheel to connect the wheel to the motor canister bearing. Making it relevant.
Finally, I assembled the whole. Most of the model was completed.